Sanders Sound Systems: MAGTECH / 2 x 500W Stereo Effektforsterker / Klasse AB

Effektforsterker 2 x 500W 8 Ohm

NOK79 900,00 inkl. mva.
  • Produktinfo
  • Tekniske spesifikasjoner
  • Vår mening om produktet

The only amplifier with a linear, voltage regulator Patent Pending.

The popularity and success of the Electrostatic Amplifier (the "ESL Amp") for driving electrostatic speakers led to many requests for a companion amplifier that was specifically designed for driving conventional magnetic speakers. Two years in development, the Magtech amplifier is that amplifier.

DESIGN PHILOSOPHY
Magnetic speakers differ from electrostatic speakers in one fundamental way -- they require massive amounts of current and power. This causes the power supply voltages in an amplifier to change dramatically (typically by 30%) between idle and full power.

Electronics have their lowest distortion and optimum performance at a specific design voltage. If the voltage varies, the amplifier´s performance will suffer.

An additional problem in amplifiers is that they require bias to eliminate crossover notch distortion and determine their class of operation. The bias will vary as the voltage does, which will further reduce performance.

An amplifier´s voltage will fluctuate wildly as dynamic music is played. This causes the amplifier´s distortion and bias to vary constantly and fail to meet its full performance potential.

As if all these problems are not enough, as an amplifier´s voltage sags under load, the power it can deliver is greatly reduced. If the voltage would remain stable, the amplifier could produce much more power. Since most audiophile speaker systems require several hundred watts of power to avoid clipping and compression of the dynamic range, power is extremely important.

THE SOLUTION
All quality, line-level electronics use voltage regulation in their power supplies to produce a stable voltage, regardless of load or the mains voltage. Audiophiles would not consider using a source component that did not have regulated power supplies. So why use amplifiers with unregulated supplies?

The main problem is heat. Amplifiers operate at much higher voltages and currents than line level source components. These higher voltages and currents forces conventional regulator designs to waste large amounts of energy, which wastes expensive electricity and causes the amplifier to get very hot.

Also, many regulator designs radiate RF (Radio Frequency) energy when switching high currents and voltages. This RF gets into the amplifier´s electronics and can cause instability, oscillation, and noise. As a result of these problems, modern power amplifiers do not use regulated power supplies and fail to take advantage of the benefits available from doing so.

Sanders has solved these problems by developing a voltage regulator that is essentially 100% efficient. There is no heat dissipated by the regulator system. There is no high-power/high-voltage switching that causes heat generation or RF problems. 

The regulator in the Magtech amplifier maintains a stable voltage regardless of load or reasonable changes in the line voltage feeding the amplifier. It runs stone cold, produces zero RF energy, and is simple and reliable. 

Unlike other amplifiers, the distortion in the Magtech amplifier is virtually unchanged regardless of power level. The bias is stable regardless of load. 

The regulator makes it possible to obtain a 50% increase in power over the same amplifier operated unregulated. In its stereo form, the Magtech will deliver 500 watts/channel into an 8 ohm load and 800 watts/channel into a 4 ohm load. 

The Magtech is built into the same chassis as the ESL Amp, so it is compact enough (17" wide, 5-1/2" tall, 14" deep) to place on a shelf or into a cabinet. It is also light enough (54 pounds) to be picked up. Like the ESL amp, it runs very cool and may be left on continually without concern for power usage.

The Magtech amplifier also uses the same advanced technology that makes the ESL amp able to drive the most difficult loads without performance-degrading, protective circuitry. The Magtech amplifier is the only amplifier on today´s market that features a linear voltage regulator. The result is a compact, yet extremely powerful amplifier that is ideally suited to driving the most difficult magnetic speakers.

Specifications 
Power (Stereo Version)
500 watts RMS per channel into an 8 ohm load
800 watts RMS per channel into a 4ohm load 
Bandwidth DC through 100kHz 
Slew Rate 500 Volts/microsecond 
Input voltage required for full output 2 Volts 
Input Impedance 50kohm (both balanced and unbalanced) 
Gain 26dB 
Noise More than 110dB below rated output 
Damping Factor Greater than 600 into an 8 ohm load 
THD Less than 0.004%, 20 Hz - 20 KHz 
IMD Less than 0.003%, 20 Hz - 20 KHz 
Dimensions 17" wide x 5.5" tall x 16" deep (43cm x 14cm x 40.6cm) 
Weight 55 pounds (25 Kgs)

MAGTECH
Kanaler 2
Effekt i 8 Ohm 500W
Effekt i 4 Ohm 900W 
Effekt i 2 Ohm  
Klasse A og/eller Klasse A/B AB
Balansert / Ubalansert Balansert
Innganger  RCA 1par
Innganger XLR 1 par 
Høyttalerterminaler 1 par
Strømforsyning  
Strømkapasitet  
Slew Rate / Spenningsvariasjon 400Volt pr mikrosekund
 Ladekapasitet  
Gain - Effekttrinn 26db 
Båndbredde DC - >100kHz 
Forvrengning  THD Mindre enn 0,01% - 20Hz til 200kHz ved full effekt  4-8Ω. 0,0024% ved lavt signalnivå
Forvrengning TIM Mindre enn 0,01% - 20Hz til 200kHz ved full effekt 4-8Ω. 0,0024% ved lavt signalnivå
Signal / Støyforhold >120db 
Inngangsimpedance - ubalansert 100kOhm
Inngangsimpedance - balansert 100 kOhm
Utgangsimpedance  Mindre enn 0,02 Ohm
Dempingsfaktor 600 v/ 8 Ohm
Finish Sort eller Sølv
Dimensjon 43cm x 40,6cm x 14cm
Vekt 23,2kg
Garanti Norge 2 År